Honda ACCORD 2008 Manual

INTERACTIVE NETWORK
2008 ACCORD - Navigation System Diagnostic Mode
Start-up procedure and Diagnostic Menu
There are two ways to enter the diagnostic mode:
1. Start the vehicle and at the globe screen connect the SCS service connector to the navigation service connector located behind the navigation unit in the trunk.
The sereen changes to the System Links screen and automatically begins running the self diagnostic. See the System Links section for more information.
NOTE: When finished troubleshooting, make sure to remove the SCS service connector.
2. Start the vehicle, and at the disclaimer screen use the navigation display hard buttons as described below:
Make sure the battery is in good condition then press and hold the three buttons (MAP/GUIDE, MENU, and CANCEL), and keep them pressed for about 3
seconds. The display screen will go directly to the Select Diagnosis Items menu shown below.
Self-Diagnosis Mode (runs the automatic diagnosis of the navigation system)
Detail Information & Setting (allows you to manually diagnose the navigation system)
System Links
1. Enter this screen by connecting the SCS connector or by selecting Self Diagnosis Mode from the navigation screen main menu. The message at the bottom of
the screen flashes indicating the diagnostic is running. Make sure you enter the audio anti-theft code.
NOTE:
The system cannot complete a full diagnosis unless the engine is runnig.
DTC 1501 and/or 2703 can be stored when the ignition switch is at ACCESORY (I). With the ignition switch is in ACCESORY (I), the A/C unit is turned off
and the navigation unit loses communication and stores DTCs. Therefore, there is a possibility that the system is normal even DTC 1501 and/or 2703 is
stored. Check system links with the engine running, and if it shows normal, the system is OK at this time.
2. Rotate the interface dial to select the icon you want to diagnose. Push in the selector to see the details of that diagnostic function.
The System Links function runs automatically and displays a flashing message at the bottom of the screen reminding you to have the engine running for the test.
The diagnostic tests the following:
The cables connecting the navigation components shown in the block diagram.
The results from the various components shown in the block diagram.
The microphone is tested by listening to the bong sound produced by the navigation unit from the speakers when the diagnostic is started. This requires that
the audio system be operating normally.
American Honda Motor Co., Inc. Page 1 of 20