Honda Accord 2008 Manual page 1721

07/11/02 09:34:16 61TA0000_200_0154
Dashboard
Driver's Dashboard Lower Cover Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
• Take care not to scratch the dashboard and its related
parts.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Adjust the steering column upward.
2. Remove the driver's dashboard lower cover (A).
–1 Pull out the bottom of the cover to detach the
–2 Pull out along the edge of the cover to detach
–3 Release the bottom hooks (D).
–4 Disconnect the VSA OFF switch connector (E).
＊０１
Fastener Locations
B, C
20-152
clips (B).
the clips (C).
: Clip, 8
C
C C
C
B
A
E
3. If necessary, remove the screws, and detach the
hooks (A), then remove the pocket trim (B) from the
driver's dashboard lower cover (C).
Fastener Locations
: Screw, 3
B
4. Install the cover in the reverse order of removal,
and note these items:
• Make sure the VSA OFF switch connector is
plugged in properly.
• If the clips are damaged or stress-whitened,
replace them with new ones.
• If the bottom hooks are damaged or stress-
whitened, replace the cover with a new one.
• Push the clips and the hooks into place securely.
C
C
B
D
ＴＡ０８Ａ００Ｊ２６２２０２１９３０１ＫＤＡＴ１０
A
A
A
C
＊０２