Honda Accord 2008 Manual page 2268

07/11/02 09:37:15 61TA0000_220_0238
Ceiling Light Test/Replacement
1. Turn the ceiling light switch OFF.
2. Carefully pry the lens (A) off with a small
screwdriver.
Ceiling Light: 8 W
＊０１
3. Remove the screws, then remove the ceiling light
(B).
4. Disconnect the 3P connector (C) from the ceiling
light.
5. Check for continuity between the terminals.
• There should be continuity between the No. 1
and No. 2 terminals with the switch in the
MIDDLE position.
• There should be continuity between the No. 2
and No. 3 (body ground) terminals with the
switch in the ON position.
• There should be no continuity between the No. 1
and No. 2 terminals, and between the No. 2 and
No. 3 (body ground) terminals with the switch in
the OFF position.
6. If the continuity is not as specified, check the bulb.
If the bulb is OK, replace the ceiling light.
7. Install the light in the reverse order of removal.
ＴＡ０８Ａ００Ｊ３２３０００１６３０１ＦＨＡＴ１０
C
Not used
A
Trunk Light Test/Replacement
1. Open the trunk lid.
2. Carefully pry out the trunk light (A).
Trunk Light: 5 W
B
3. Disconnect the 2P connector (B) from the light.
4. Check for continuity between the No. 1 ( ) and
No. 2 ( ) terminals. There should be continuity. If −
there is no continuity, check the bulb. If the bulb is
OK, replace the trunk light assembly.
5. Install the light in the reverse order of removal.
ＴＡ０８Ａ００Ｊ３２３７３７６０４０１ＦＨＡＴ０１
B
A
＋ ( ) −
( )
＋
22-235 22-235
＊０１