Honda Accord 2008 Manual page 2332

07/11/02 09:40:00 61TA0000_220_0302
Wiper Motor Test
4-door
1. Remove the driver's side wiper arm (see page
22-301).
2. Remove the left side cowl cover (see page 22-301).
3. Disconnect 5P connector (A) from the wiper motor
(B).
＊０１
4. Test the motor by connecting battery power to the
No. 3 terminal and ground to the No. 2 terminal of
the wiper motor 5P connector. The motor should
run at low speed.
5. Test the motor by connecting battery power to the
No. 5 terminal and ground to the No. 2 terminal of
the wiper motor 5P connector. The motor should
run at high speed.
6. Connect an analog ohmmeter to the No. 4 and
No. 2 terminals, and run the motor at low or high
speed. The needle of the ohmmeter should pulse.
7. If the motor does not run or fails to run smoothly,
or there is no pulse, replace the motor.
ＴＡ０８ＡＢ４Ｊ５４３０００６５７２１ＦＥＡＴ００
B
A
2-door
1. Remove the driver's side wiper arm (see page
22-301).
2. Remove the left side cowl cover (see page 22-301).
3. Disconnect 5P connector (A) from the wiper motor
(B).
B
4. Test the motor by connecting battery power to the
No. 3 terminal and ground to the No. 4 terminal of
the wiper motor 5P connector. The motor should
run at low speed.
5. Test the motor by connecting battery power to the
No. 5 terminal and ground to the No. 4 terminal of
the wiper motor 5P connector. The motor should
run at high speed.
6. Connect an analog ohmmeter to the No. 1 and
No. 4 terminals, and run the motor at low or high
speed. The needle of the ohmmeter should pulse.
7. If the motor does not run or fails to run smoothly,
or there is no pulse, replace the motor.
ＴＡ０８ＡＢ２Ｊ５４３０００６５７２１ＦＥＡＴ００
A
22-299 22-299
＊０２