07/11/02 09:41:46 61TA0000_220_0332
4. With the connector still disconnected, make these input tests at the connector.
• If any test indicates a problem, find and correct the cause, then recheck the system.
• If all the input tests prove OK, go to step 5.
Cavity
Wire
1
RED
2
ORN
9
GRN
10
BLU
18
BLU
19
PNK
Test condition
Test: Desired result
Combination light
Attach to ground:
switch ON
The dash lights, audio unit light,
and climate (or HVAC) control unit
light should come on full bright.
Combination light
Attach to ground:
switch ON
The moonroof switch light and
seat heater switch lights should
come on full bright.
Ignition switch ON
Measure the voltage to ground:
(II), turn signal
There should be battery voltage
switch in RIGHT
when the lights are flashing.
Ignition switch ON
Measure the voltage to ground:
(II), turn signal
There should be battery voltage
switch in LEFT
when the lights are flashing.
Disconnect the
Check for continuity between the
driver's under-
No. 18 terminal and the driver's
dash fuse/relay
under-dash fuse/relay box
box connector P
connector P (20P) No. 5 terminal:
(20P)
There should be continuity.
Check for continuity to ground:
There should be no continuity.
Disconnect the
Check for continuity between the
driver's under-
No. 19 terminal and the driver's
dash fuse/relay
under-dash fuse/relay box
box connector P
connector P (20P) No. 6 terminal:
(20P)
There should be continuity.
Check for continuity to ground:
There should be no continuity.
Possible cause if desired result is
not obtained
•
Faulty LEDs and bulbs
•
An open in the wire
•
Faulty LEDs and bulbs
•
An open in the wire
•
Faulty driver's MICU
•
Faulty combination light switch
•
An open in the wire
•
Faulty driver's MICU
•
Faulty combination light switch
•
An open in the wire
An open in the wire
A short in the wire
An open in the wire
A short in the wire
(cont'd)
22-329