07/11/02 09:38:46 61TA0000_220_0278
5. Turn the ignition switch to LOCK (0), open and close the driver's door, then disconnect the 37P connector from the
front passenger's power window switch again.
6. With the connector still disconnected, make these input tests at the connector.
• If any test indicates a problem, find and correct the cause, then recheck the system.
• If all the input tests prove OK, replace the front passenger's power window switch, then go to step 7.
Cavity
12
24
29
7. With the front passenger's power window AUTO UP/AUTO DOWN function, reset the power window control unit
(see page 22-253).
Wire
Test condition
BLU
Under all conditions,
RED
connect No. 25 and
No. 24 (or No. 12)
terminals, and No. 12
(or No. 24) and
No. 37 terminals with
jumper wires.
BLU
Under all conditions,
disconnect the power
window master
switch 37P connector.
Test: Desired result
Check front passenger's power
window motor operation:
The front passenger's power
window should open (or close).
Check for continuity between
the No. 29 terminal and the
power window master switch
37P connector No. 27 terminal:
There should be continuity.
Possible cause if desired result
is not obtained
•
Faulty front passenger's
power window motor
•
An open in the wire
An open in the wire
22-275