Honda Accord 2008 Manual page 2403

07/11/02 09:43:04 61TA0000_220_0373
Power Mirrors
Power Mirror Switch Test/
Replacement
1. Remove the power window master switch.
• 4-door (see page 22-283)
• 2-door (see page 22-283)
2. Disconnect the 13P connector from the power
mirror switch (A).
＊０１
3. Check for continuity between the terminals in each
switch position according to the table.
＊０２
Position
L
R
4. If the continuity is not as specified, remove the
screws and replace the power mirror switch.
22-370 22-370
ＴＡ０８Ａ００Ｊ３４３０００４４０４１ＦＨＡＴ０１
Terminal
10 11
2 5 6
UP
DOWN
LEFT
RIGHT
UP
DOWN
LEFT
RIGHT
Power Mirror Actuator Test
1. Remove the mirror mount cover (see page 20-55).
2. Disconnect the 8P connector (A) from the power
mirror actuator (B).
B
A
3. Check actuator operation by connecting battery
power and ground according to the table.
Position
TILT UP
TILT DOWN
SWING LEFT
SWING RIGHT
4. If the mirror fails to work properly, check for an
open in the wire between the connector and the
mirror holder. If the wire is OK, replace the mirror
actuator.
12
13
Defogger Test
5. Measure the resistance between the No. 1 and
No. 3 terminals of the 8P connector. There should
be about 7 .
6. If the resistance is not as specified, check for an
open in the wire between the connector and the
mirror holder. If the wire is OK, replace the mirror
holder.
ＴＡ０８Ａ００Ｊ３４３０００４４０３１ＦＥＡＴ０２
Terminal side of
male terminals
Terminal
6 7
＊０１
A
＊０２
8