Honda Accord 2008 Manual page 2305

07/11/02 09:38:45 61TA0000_220_0275
Power Windows
Power Window Master Switch Input Test (cont'd)
5. Turn the ignition switch to LOCK (0), open and close the driver's door, then disconnect the 37P connector from the power window master
switch again.
6. With the connector still disconnected, make these input tests at the connector.
• If any test indicates a problem, find and correct the cause, then recheck the system.
• If all the input tests prove OK, the door multiplex control unit must be faulty, replace the power window master switch.
NOTE: After replacing the power window master switch, reset the power window control unit (see page 22-253).
Cavity
12
24
23
(4-door)
36
(4-door)
21
(4-door)
34
(4-door)
26
(4-door)
27
33
35
22-272
Wire Test condition
YEL Turn the ignition switch ON (II),
GRN connect No. 25 and No. 24 (or
No. 12) terminals, and No. 12 (or
No. 24) and No. 37 terminals with
jumper wires.
GRN Turn the ignition switch ON (II),
connect No. 25 and No. 36 (or
LT BLU No. 23) terminals, and No. 23 (or
No. 36) and No. 37 terminals with
jumper wires.
LT BLU Turn the ignition switch ON (II),
connect No. 25 and No. 34 (or
LT GRN No. 21) terminals, and No. 21 (or
No. 34) and No. 37 terminals with
jumper wires.
PNK Turn the ignition switch ON (II),
connect No. 25 and No. 26
terminals with a jumper wire.
BLU Disconnect the front passenger's
power window switch 37P
connector.
BLU Disconnect the driver's under-
dash fuse/relay box connector P
(20P)
PNK Disconnect the driver's under-
dash fuse/relay box connector P
(20P)
Test: Desired result
Check driver's power window •
motor operation:
The driver's power window •
should open (or close).
Check left rear power window •
motor operation: •
The left rear power window
should open (or close). •
•
Check right rear power window •
motor operation:
The right rear power window •
should open (or close). •
•
•
Check left and right rear power •
window switch lights: •
The left and right rear power •
window switch lights should come
on. •
Check for continuity between the An open in the wire
No. 27 terminal and the front
passenger's power window switch
37P connector No. 29 terminal:
There should be continuity.
Check for continuity to ground: A short in the wire
There should be no continuity.
Check for continuity between the An open in the wire
No. 33 terminal and the driver's
under-dash fuse/relay box
connector P (20P) No. 5 terminal:
There should be continuity.
Check for continuity to ground: A short in the wire
There should be no continuity.
Check for continuity between the An open in the wire
No. 35 terminal and the driver's
under-dash fuse/relay box
connector P (20P) No. 6 terminal:
There should be continuity.
Check for continuity to ground: A short in the wire
There should be no continuity.
Possible cause if desired result is
not obtained
Faulty driver's power window
motor
An open in the wire
Poor ground (G601)
Faulty left rear power window
switch
Faulty left rear power window
motor
An open in the wire
Faulty passenger's under-dash
fuse/relay box
Poor ground (G651)
Faulty right rear power window
switch
Faulty right rear power window
motor
An open in the wire
Faulty LED
Poor ground (G601, G651)
Faulty left or right rear power
window switch
An open in the wire