Honda Accord 2008 Manual page 2354

07/11/02 09:41:44 61TA0000_220_0324
DTC B1176: Fuel Level Sensor (Fuel Gauge
Sending Unit) Circuit Short
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN System
Diagnosis Test Mode A (see page 22-120).
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to LOCK (0) and then back
to ON (II).
3. Wait for 30 seconds.
4. Check for DTCs with the HDS.
Is DT C B117 6 indicated?
YES − Go to step 5.
−
NO Intermittent failure, the fuel level sensor
circuit is OK at this time. Check for worn/missing
insulation or an internal short in the wire.
5. Turn the ignition switch to LOCK (0).
6. Disconnect the fuel tank unit 4P connector.
7. Clear the DTCs with the HDS.
8. Turn the ignition switch to ON (II).
9. Wait for 30 seconds.
10. Check for DTCs with the HDS.
Is DT C B117 6 indicated?
−
YES Go to step 11.
NO − Replace the fuel gauge sending unit (see page
11-377).
11. Disconnect the gauge control module 32P
connector.
12. Check for continuity between the gauge control
module 32P connector No. 27 terminal and body
ground.
GAUGE CONTROL MODULE 32P CONNECTOR
FUEL UNIT
(PUR)
Wire side of female terminals
Is there continuity?
YES − Repair a short in the wire between the gauge
control module and the fuel tank unit.
−
NO Replace the gauge control module.
ＴＡ０８Ａ００Ｋ７３２０００Ｙ１１７６ＦＡＡＴ００
＊０１
22-321