Honda Accord 2008 Manual page 2391

07/11/02 09:42:57 61TA0000_220_0361
Accessory Power Sockets
Front Accessory Power Socket Test/Replacement
NOTE: If all of the front and console accessory power
sockets do not work, check the No. 18 (7.5 A) fuse in the
driver's under-dash fuse/relay box and ground (G503)
first.
1. Remove the center console panel (see page 20-145).
2. Disconnect the 2P connector (A) from the front
accessory power socket (B).
＊０１
3. Inspect the connector terminals to be sure they are
all making good contact.
• If the terminals are bent, loose, or corroded,
repair them as necessary and recheck the system.
• If the terminals look OK, go to step 4.
4. Turn the ignition switch to ACCESSORY (I).
5. Measure the voltage between the front accessory
power socket 2P connector No. 1 terminal and body
ground. There should be battery voltage.
• If there is battery voltage, go to step 6.
• If there is no battery voltage, check for:
– Blown No. 23 (15 A) fuse in the driver's under-
– Faulty front accessory power socket relay.
– Poor ground (G 601).
– An open in the wire.
22-358
A
Wire side of female terminals
WHT BLK
dash fuse/relay box.
6. Check for continuity between the front accessory
power socket No. 2 terminal and body ground.
There should be continuity.
• If there is continuity, replace the power socket;
go to step 7.
• If there is no continuity, check for:
– Poor ground (G 503).
– An open in the wire.
7. Remove the socket (A).
B
8. Remove the housing (A) from the panel.
9. Install the power socket in the reverse order of
removal.
ＴＡ０８Ａ００Ｊ５４２１１５１２４０２ＦＨＡＴ００
＊０２
A
＊０３
A