Honda Accord 2008 Manual page 2037

07/11/02 09:26:10 61TA0000_220_0007
Body Electrical
General Troubleshooting Information (cont'd)
• Check for loose retainers (A) and rubber seals (B).
＊０５
A
• The backs of some connectors are packed with
dielectric grease. Add grease if necessary. If the
grease is contaminated, replace it.
＊０６
• Insert the connector all the way and make sure it is
securely locked.
• Position wires so that the open end of the cover faces
down.
＊０７
22-4
Handling Wires and Harnesses
• Secure wires and wire harnesses to the frame with
• Remove clips carefully; don't damage their locks (A).
B
A
• After installing harness clips, make sure the harness
• Keep wire harnesses away from exhaust components
• Seat grommets in their grooves properly (A). Do not
(P/N 08798-9001)
DOWN
their respective wire ties at the designated locations.
A
doesn't interfere with any moving parts.
and other hot parts, from sharp edges of brackets and
holes, and from exposed screws and bolts.
leave grommets distorted (B).
A
＊０８
＊０９
B