Honda Accord 2008 Manual page 2286

07/11/02 09:38:01 61TA0000_220_0256
Resetting the Power Window Control Unit
Resetting the power windows are required when any of
the following have occurred:
• Power window regulator replacement, removal/
installation, or repair
• Power window motor replacement, removal/
installation, or repair
• Window run channel replacement or removal/
installation
• Front passenger's power window switch replacement
or removal/installation
• Door glass replacement, removal/installation, or
repair
• Power is removed from the driver's power window
master switch or front passenger's power window
switch while the power window timer is ON.
: With front passenger's power window AUTO
UP/AUTO DOWN function
NOTE: If the front passenger's power window has lost
power when the key off timer is ON, it cannot be
operated from the driver's switch and must be reset
from the front passenger's power window switch.
Using the HDS
1. Connect the HDS to the data link connector.
2. Turn the ignition switch to ON (II), then enter the
vehicle's VIN and mileage at the prompts.
3. Select BODY ELECTRICAL from the SYSTEM
SELECT menu.
4. From the BODY ELECTRICAL SYSTEM SELECT
menu, select POWER WINDOWS.
5. From the MODE menu, select ADJUSTMENTS.
6. From the ADJUSTMENT menu, select WINDOW
RESET for driver's side (passenger's side) window.
7. Follow the prompts on the screen.
8. Confirm that the power window control unit is reset
by using the power window AUTO UP and AUTO
DOWN function.
Without the HDS
NOTE:
• Do each bullet in step 4 within 5 seconds of each
other.
• The front passenger's power window must be rest
from the front passenger's power window switch.
: With front passenger's power window AUTO
UP/AUTO DOWN function
1. Turn the ignition switch to ON (II).
2. Move the power window all the way down by using
the power window DOWN switch.
3. Open the driver's door.
4. Do the following three times before going to step 5:
• Turn the ignition switch to LOCK (0).
• Push and hold the power window DOWN switch.
• Turn the ignition switch ON (II).
• Release the power window DOWN switch.
5. Confirm that AUTO UP no longer works. If AUTO
UP still works, go back to step 1.
6. Move the power window all the way down using
the power window DOWN switch.
7. Pull up and hold the power window UP switch until
the power window is all the way up, then continue
to hold the switch for 1 second.
8. Confirm that the power window control unit is reset
by using the power window AUTO UP and AUTO
DOWN function.
• If the power window still does not work in AUTO,
repeat the procedure several times, paying close
attention to the 5 second time limit between
steps.
• If it still does not work, go to B-CAN System
Diagnosis Test Mode A (see page 22-120).
ＴＡ０８Ａ００Ｊ５４４６０６４１９５３ＬＢＡＴ００
22-253