Table of Contents
Advertisement
Setting up IP Unicast Routing Information
1
From the user interface of the D9824, choose System Settings > IP Settings > IP
Unicast Routing. The IP Routing page is displayed.
2
From the RIP drop-down list, choose Enable to enable the Routing Information
Protocol (RIP). Otherwise, choose Disable. This is a standard protocol for
automatic unicast route discovery. If enabled, the routing information is
displayed in the Installed Unicast Routes table.
3
Click Apply.
4
In the Static Unicast Routing table, you can set the static unicast routing
information used to by MPEGoIP and MPE outputs to send data packets. It can
also be used to find hosts behind a router (for example, an FTP server, a syslog
server, or an NTP server).
To add a unicast route:
a
Click Add Row.
b In the Destination IP Address field, enter the destination IP address that sets
the destination for the unicast route.
c
In the Mask field, enter the number of CIDR (Classless Inter-Domain
Routing) bits in the network mask (8 to 30).
Configuring System Settings
251
- Quick Links:
- D9824 Advanced Multi Decryption Receiver
Hide quick links:
Advertisement
Table of Contents
