Setting Up Audio - Cisco D9865 Installation And Operation Manual

Setting up Audio

Setting up the Audio
Proceed as follows to select the audio source.
1. From the Setup Menu screen, select Audio Setup and click OK.
2. The following table describes each of the options:
Selection
Stereo/Mono
DRC Mode
Digital Audio
Preference
PMT Audio Source None
4-42
Options
Stereo
Mixed
L-MONO
R-MONO
RF Mode
Line Mode
PCM
Dolby Digital
Compressed
(Dolby Digital
Plus)
AUD1 to
AUD64
D9865 Satellite Receiver Installation and Operation Guide
Description
Left and right channels are output on L
and R respectively.
Left and right channels are combined and
output on both L and R.
Left channel is output on L and R.
Right channel is output on L and R.
This setting is normally used for analog
cable modulators, when limited dynamic
range is desired.
Setting used when full dynamic range is
allowed.
Set the compressed audio type.
For more information on the settings, see
the table in Digital Audio Preference
Settings, on page 4-43.
Select the PMT Audio Source for the audio
channel.
Default
Stereo
RF Mode
PCM
AUD1
4035197 Rev C