Table of Contents
Advertisement
Chapter 5 Web GUI Setup and Monitoring
Setting up Audio and Video Information
Setting up the Video Parameters
1
From the user interface of the D9854/D9854-I, choose Audio & Video > Video
Decoding. The Video Setup page is displayed.
2
From the Primary Video Output drop-down list, choose the primary video
output format for local decoding. The options are Auto, HD 720p, HD 1080i, or
SD.
3
Choose whether to enable or disable the component tri-synch from the
Component Tri-Synch drop-down list.
4
From the Standard Definition Output drop-down list, choose the actual
standard definition output format of the primary video if the PV Output is set to
SD. The options are Auto, NTSC, PAL-N (AR), PAL-M, or PAL-B/G/I/D. You
must use NTSC for 525-line systems and PAL-B/G/I/D for 625-line systems.
5
From the Standard Definition Aspect Ratio drop-down list, choose the Standard
Definition aspect ratio of your TV monitor (4:3 or 16:9). The default is 4:3. Set it to
the corresponding value.
6
From the Selected Aspect Ratio Conversion drop-down list, choose the aspect
ratio that the receiver will perform on the incoming signal for the picture to be
displayed correctly on your TV, based on the Standard Definition Aspect Ratio
selection.
The options are None, Auto, Auto AFD, 16:9 L/B, 4:3 P/B, 14:9, 4:3 CCO, and
16:9 Scale. The default is Auto.
206
Advertisement
Table of Contents
