Setting Up Si Receive Parameters - Cisco D9824 Installation And Configuration Manual

Setting up SI Receive Parameters

Note: If the unit is in a disaster recovery or NIT retune recovery mode, an error
message is displayed, informing you that any changes made to the page will
interrupt the disaster recovery or NIT retune process. The error message appears
when you load, refresh, or apply changes to the page. For more information on NIT
retune, see NIT Retune Recovery (on page 10). For more information on disaster
recovery, see Disaster Recovery (on page 7).
1 From the user interface of the D9824, choose Input > SI Receive Setup. The SI
Receive Setup page is displayed.
2 In the Custom Tuning Mode area, from the Acquisition Mode drop-down list,
choose the tables required for the service list creation and signal acquisition. The
selections are Auto, Basic, or Custom. The default is Basic. If you select Basic, it
requires NIT to be present. If you select Auto, it uses all the available service list
tables and it will acquire if any table is present.
Setting up Input Information
165