Table 7: Beep And Honk Settings For All Alarms - NorthStar 951X Operator's Manual

Chapter 10 - Using Other Special Functions
Sound Type
Beep All alarms
Beep Anchor watch
Honk All alarms
Honk Anchor watch
Page 138
sequence stops when the alarms either automatically clear or
you manually clear them.
If you want all alarms to honk, you must first set the
ON
field to .
To set all alarms to honk:
1. Press the &85625 3$' to highlight the HONK OUTPUT
field, then press the (',7 $/$50 menu key.
2. Press the &85625 3$' to select ALL ALARMS.
3. Press the (17(5 key.
Table 7 below illustrates exactly how to set the anchor-watch
alarm and all other alarms to the desired audio.

Table 7: Beep and honk settings for all alarms

Setting(s)
Set alarm audio field to ON
Set alarm audio field to ON
Set anchor alarm field to ON
Set alarm audio field to ON
Set honk output field to ALL
ALARMS
Set anchor alarm field to ON
Set honk output field to
ANCHOR ALM
NOTE:
Description
The unit's standard alarm beep.
The unit's standard alarm beep.
Exclamation point flashes on the
ALARMS screen (952) or
BACKLIGHT SCREEN
simultaneously emits an output sound
for half a second, followed by silence for
half a second.
For 10 seconds, the exclamation point
flashes on the ALARMS screen (952) or
ALARMS & BACKLIGHT
(951), and the alarm beeps (if alarm
audio is on), then the honk sequence
starts.
951/952 Operator's Manual Rev. B
ALARM AUDIO
ALARMS &
(951); the unit
screen