Table 12: Beep And Honk Settings For All Alarms - NorthStar 951X Installation Manual

Honking for all
Sound
Beep
Beep
951/952 INSTALLATION MANUAL Revision B
Downloaded from www.Manualslib.com
Instead, you must clear the anchor alarm in either of the following two
ways.
Option #1:
1. Press the 67$5 key once to display the ALARMS screen, then press
the &/($5 $/$50 menu key.
Option #2:
1. Press the 67$5 key once to display the ALARMS screen.
2. Press the &85625 3$' to highlight the HONK OUTPUT option, then
press the (',7 $/$50 menu key.
3. Press the &85625 3$' to select either 200 PPNM (used to interface
to speed log devices), or ALL ALARMS, instead of ANCHOR ALM, then
press the (17(5 key.
Instead of setting all alarms to beep only, you can set all alarms to honk.
This honking starts simultaneously with the flashing exclamation point
alarms
on the ALARMS screen (952) or ALARMS & BACKLIGHT screen (951). After
you set all alarms to honk, the system emits an output sound for half a
second, followed by silence for half a second. This repeatable honking
sequence stops when the alarms either automatically clear or you manu-
ally clear them.
If you want all alarms to honk, you must first set the
AUDIO
To set all alarms to honk:
1. Press the 67$5 key once to display the ALARMS screen (952) or
ALARMS & BACKLIGHT screen (951).
2. Press the &85625 3$' to highlight the HONK OUTPUT option, then
press the (',7 $/$50 menu key.
3. Press the &85625 3$' to select ALL ALARMS, then press the
(17(5 key.
Table 12 below describes how to set the anchor-watch alarm and all other
alarms to the desired audio.

Table 12: Beep and honk settings for all alarms

Type Setting(s)
Set alarm audio field to ON
All alarms
Set alarm audio field to ON
Anchor watch
Set anchor alarm field to ON
manuals search engine
NOTE:
ON.
option to
Description
The unit's standard alarm beep.
The unit's standard alarm beep.
SECTION THREE - Interfacing
ALARM
Page 57