Table of Contents
Advertisement
To display the details of any fault, select it with the cursor pad
and press Details .
The Fault History screen is similar, except that it displays past
faults along with the times of occurrence of each fault.
Save/Load
See the Setup and Calibration section of this manual.
Additional Info bars
When the SmartCraft system is installed, two additional info bars
can be displayed on the Chart screen.
One info bar displays Engine RPM, Depth (if available) and COG.
The second info bar displays Sea Pump Pressure, Oil Pressure (or
Oil Level for outboard engines), Voltage and Fuel Flow.
SmartCraft alarms
SmartCraft alarms are sounded regardless of whether or not the
SmartCraft screen is enabled for display. A gauge that is
reporting an alarm condition will display with a red bezel. In
addition, a standard 6000i alarm will be displayed and sounded.
The fourth menu key on primary SmartCraft screens displays
current SmartCraft alarms.
On the 6000i's alarms screen, the Active faults... menu key
displays any available details for SmartCraft alarms. This key is
only displayed if there are active faults.
– 8 –
GMSMCRFT Rev A
Advertisement
Table of Contents
