Table of Contents
Advertisement
by 13 seconds of silence; 3 seconds of honking followed by 12
seconds of silence, and so forth, until the honking is up to 14
seconds followed by 1 second of silence. This 3.5-minute honk
cycle repeats forever unless you clear the anchor alarm. This
honk does NOT automatically clear with the following
conditions:
•
your vessel moves back into the anchor-alarm radius
•
you change the anchor-alarm radius
•
you select a new "drop anchor" position
•
you turn off the anchor alarm
Instead, you must clear the anchor alarm in either of the
following two ways.
Option #1:
1. Press the STAR key once to display the ALARMS &
BACKLIGHT screen, then press the CLEAR ALARM key.
Option #2:
1. Press the STAR key once to display the ALARMS &
BACKLIGHT screen.
2. Press the CURSOR PAD to highlight the HONK OUTPUT
field, then press the EDIT ALARM key.
3. Press the CURSOR PAD to select either 200 PPNM or ALL
ALARMS, instead of ANCHOR ALM, then press the ENTER
key.
Honking for all alarms
Instead of only a beep for all alarms, you now can set all alarms
to honk. This honking will start simultaneously with the flashing
exclamation point on the ALARMS & BACKLIGHT screen. After
you set all alarms to honk, the system emits an output sound for
half a second, followed by silence for half a second. This
repeatable honking sequence stops when the alarms either
automatically clear or you manually clear them.
Note: If you want all alarms to honk, you must set the ALARM
AUDIO field to ON.
032101
– 5 –
Addendum P/N GM210
Advertisement
Table of Contents
