NorthStar 951X Operator's Manual page 66

Chapter 4 - Using Charts
Changing the track
control
Page 56
effect, a warning message is given as a reminder that you
should verify whether you still need the offset.
To remove a chart offset:
1. From the CHART SETUP/STATUS screen, press the 6(7
&+$57 2))6(7 menu key. It isn't necessary to come to a
stop before removing a chart offset; you can press the
(17(5 key when the INFO window asks you to stop.
2. Press the 5(029( 2))6(7 menu key and then the
(17(5 key.
3. Press the 5(7851 menu key twice to return to the
CHART screen.
A chart calibration error may appear in only a single chart
within a cartridge, which means that you may need a different
chart offset for different areas of a cartridge. Since it isn't
always obvious when the 951/952 switches automatically to a
different chart within that cartridge, you should be aware of
these limitations if you choose to use a chart offset.
The Northstar unit displays your track history as a series of
dots indicating the path you've recently traveled.
You can choose how often the unit stores a position fix as a
point in your track history; up to 1,024 position fixes may be
stored. When this limit is reached, the unit starts erasing the
oldest points to add your new points to the track line. The
more frequently you mark your track, the quicker you fill up
the track memory. The maximum length of the track depends
on how often points are stored.
CAUTION!
951/952 Operator's Manual Rev. B