GE N60 Instruction Manual page 251

5 SETTINGS
When the protocol selection is set via the software or keypad, all aggregators whose protocol is not set to None are
set to the last protocol saved (that is, IEEE C37.118 or IEC 61850-90-5) to any aggregators, as both IEEE C37.118
and IEC 61850-90-5 simultaneous streaming is not possible.
NOTE

PATH: SETTINGS SYSTEM SETUP
TION
 37.118 AGGR 1
 CONFIGURATION
MESSAGE
MESSAGE

PATH: SETTINGS SYSTEM SETUP
TION
 90-5 AGGR 1
 CONFIGURATION
MESSAGE
MESSAGE
MESSAGE
• PMU AGGREGATOR1 PROTOCOL: This setting selects if the IEEE C37.118 or IEC 61850-90-5 standard is used.
Because one protocol is supported at a time in a device, this setting applies to all PMU aggregators.
• PMU AGGREGATOR1 IDCODE: Numeric identifier of the Aggregator / PDC function. In an IEEE C37.118 output
stream, this identifies the ID of the aggregator, which is only used if there is more than 1 PMU mapped into an aggre-
gator.
• PMU AGGREGATOR1 PMU1: If set to "Yes" aggregator 1 includes the PMU1 data set in the reporting data stream.
AGGREGATOR1 does not include PMU1 data set in the report if set to "No".
Only PMUs with same reporting rate can be assigned to the same PMU AGGREGATOR.
NOTE
C37.118 AGGREGATOR 1 CONFIGURATION
• PMU AGGREGATOR1: TCP PORT: This setting selects the TCP port number to be used by this aggregator for net-
work reporting. All ports, even those of unused aggregators, must be valid and unique to avoid port number collisions.
• PMU AGGREGATOR1 UDP PORT: This setting selects the UDP port number to be used by this aggregator for net-
work reporting. All ports, even those of unused aggregators, must be valid and unique to avoid port number collisions.
• PMU AGGREGATOR1 PDC CONTROL: The synchrophasor standard allows for user-defined controls originating at
the PDC, to be executed on the PMU. The control is accomplished via an extended command frame. The relay
decodes the first word of the extended field, EXTFRAME, to drive 16 dedicated FlexLogic operands. Each aggregator
supports 16 FlexLogic operands as shown in the table. The operands are asserted for 5 seconds following reception of
the command frame. If the new command frame arrives within the 5 second period, the FlexLogic operands are
GE Multilin N60 Network Stability and Synchrophasor Measurement System

PHASOR MEASUREMENT UNIT
PMU AGGREGATOR 1
TCP PORT: 4712
PMU AGGREGATOR 1
UDP PORT: 4713
PMU AGGREGATOR 1
PDC CONTROL: Disabled

PHASOR MEASUREMENT UNIT
PMU AGGREGATOR 1
NAME:
PMU AGGREGATOR1:
PORT: 1
PMU AGGREGATOR 1:
UDP PORT: 102
PMU AGGREGATOR 1:
NUMBER OF ASDUs: 1
 
PMU AGGREGATOR 1 37.118 AGGR 1 CONFIGURA-
Range: 1 to 65534
Range: 1 to 65534
Range: Disabled, Enabled
 
PMU AGGREGATOR 1 90-5 AGGR 1 CONFIGURA-
Range: 56 character ASCII text
Range: 1, 2, 3
Range: 1 to 65534 in steps of 1
Range: 1 to 4
5.4 SYSTEM SETUP
5
5-133