Fiber-Laser Transmitters; Interface - GE N60 Instruction Manual

3 HARDWARE
The following figure shows the configuration for the 72, 73, 7D, and 7K fiber-laser modules.
The following figure shows configuration for the 2I and 2J fiber-laser module.
Observing any fiber transmitter output can injure the eye.
When using a laser Interface, attenuators can be necessary to ensure that you do not exceed the
maximum optical input power to the receiver.
a) DESCRIPTION
The following figure shows the 64K ITU G.703 co-directional interface configuration.
The G.703 module is fixed at 64 kbps. The SETTINGS > PRODUCT SETUP > DIRECT I/O > DIRECT I/O DATA
RATE setting is not applicable to this module.
NOTE
GE Multilin N60 Network Stability and Synchrophasor Measurement System
3.3 DIRECT INPUT AND OUTPUT COMMUNICATIONS
Figure 3–26: 7X LASER FIBER MODULES
Figure 3–27: 2I AND 2J LASER FIBER MODULE

3.3.3 FIBER-LASER TRANSMITTERS

3.3.4 G.703 INTERFACE
3
3-23