GE N60 Instruction Manual page 628

H.1 CHANGE NOTES
Table H–1: MAJOR UPDATES FOR N60 MANUAL REVISION AA2 (Sheet 2 of 2)
PAGE PAGE CHANGE
(AA1) (AA2)
5-31 5-31 Add
B- B- Update
H-7 H-7 Update
Table H–2: MAJOR UPDATES FOR N60 MANUAL REVISION AA1
PAGE PAGE CHANGE
(Z1) (AA1)
--- --- Add
2- 2- Update
2- 2- Update
5-105 5-105 Update
7-11 7-11 Add
8- --- Delete
--- 9- Add
--- D- Add
Table H–3: MAJOR UPDATES FOR N60 MANUAL REVISION Z1
PAGE PAGE CHANGE
(Y3) (Z1)
--- --- Add
--- --- Add
1-1 1-1 Add
1-5 1-5 Update
2-6 2-6 Update
5-24 5-24 Add
5-86 5-86 Update
5-90 5-90 Update
H
5-202 5-202 Add
Table H–4: MAJOR UPDATES FOR N60 MANUAL REVISION Y3
PAGE PAGE CHANGE
(Y2) (Y3)
-- ix Add
Table H–5: MAJOR UPDATES FOR N60 MANUAL REVISION Y2 (Sheet 1 of 2)
PAGE PAGE CHANGE
(Y1) (Y2)
All All Update
H-2
DESCRIPTION
Added Far-End Fault Indication (FEFI) section
Updated Modbus memory map and F codes
Updated product warranty from 24 months to 10 years
DESCRIPTION
Added content for IEC 60870-5-103 throughout document
Updated order codes
Updated specifications
Updated hysteresis numbers and logic diagrams in section 5.4.6 Phasor Measurement Unit
Added AGGR CONFIG MISMATCH self-test error message
Deleted chapter 8 on security, moving content to other chapters
Added Maintenance chapter, moving content from other chapters and adding new instructions to
replace the battery
Added new appendix on IEC 60870-5-103 interoperability
DESCRIPTION
Added CPU options U and V to order code tables in chapter 2, a note above Rear Terminal View
figure in chapter 3, and CPU Module Communications Wiring figure in chapter 3
Added Parallel Redundancy Protocol (PRP) to order code tables and specifications in chapter 2,
section 5.2.5d Settings > Product Setup > Communications > Network, section 6.3.1 Actual
Values > Status > PRP, and Appendix B Modbus table and F627 and F628 enumeration tables
Added General Cautions and Warnings to section 1.1.1
Revised section 1.3.1 on system requirements, including addition of support for Windows 7 and
Windows Server 2008
Updated several specifications
Added section 5.2.5e Routing
Updated Figures 5-25 and 5-26 Dual Breaker Control Scheme Logic, sheets 1 and 2
Updated Figure 5-27 Disconnect Switch Scheme Logic
Reinserted section 5.8.5c Remote Devices: ID of Device for Receiving GSSE/GOOSE Messages,
meaning the Settings > Input/Outputs > Remote Devices settings
DESCRIPTION
Added battery disposal information as chapter 0
DESCRIPTION
Minor changes throughout document
N60 Network Stability and Synchrophasor Measurement System
APPENDIX H
GE Multilin