Actions; Creating A Pos Interface Profile - Cisco 12000 User Manual

V3.1.1 router manager

Hide thumbs Also See for 12000:

Table of Contents

Standby Preempt—Allows you to set the standby preempt. The standby router waits for the set time and

takes over as the active router if the current router fails or does not respond to the packets sent.

IP Address—Enables HSRP and sets the virtual ip address.

Priority [0-255]—Allows you to set the priority value that prioritizes a potential Hot Standby router. The

allowable range is 0 to 255.

Authentication String—Enter the set authentication string. Its purpose is to avoid any damage to the

interface and can be up to eight characters in length.

Standby Hold Time [1-255]—Allows you to set the time (in seconds) for standby system to wait for the

active interface to communicate about its status. On expiry of time set, the standby interface takes over

as the active interface. The default time is 10 seconds.

Actions

Create—Choose Create to create a new profile.

Creating a POS Interface Profile

To create a POS interface profile, proceed as follows:

Choose the Cisco 12000/10720 Manager>Configuration>POS>Configuration Profile option from a

POS interface object. See

the POS Profile Dialog window.

Cisco 12000/10700 v3.1.1 Router Manager User Guide

Table 7-2 on page 7-2

for information on which objects allow you to launch

Interface Profiles

10700 12000/10720