Cisco 12000 User Manual page 492

Chapter 15 MPLS Management
Fault Management for MPLS Traffic Engineering
Figure 15-20 MPLS Tunnel Information Window—Head Tunnel Setup Tab
To view head tunnel setup information, select the head tunnel in the Select Tunnel area.
Note
Select Tunnel
The Select Tunnel area displays the following information:
Tunnel Id—Displays the tunnel identification number.
Instance—Displays the tunnel instance of the LSP. It is useful to identify multiple instances of tunnels
for the purposes of backup and parallel tunnels.
Ingress LSR—Displays the source IP address of the LSP.
Egress LSR—Displays the egress LSR IP address.
Tunnel Info
Tunnel Name—Displays the name assigned to the tunnel. This name can be used to refer to the tunnel
on the LSRs console port.
Tunnel Descr—Displays a textual string containing information about the tunnel. If there is no
description this object contains a zero length string.
Tunnel Type—Displays either head tunnel or LSP.
Signalling Protocol—Displays the signaling protocol, if any, which was used to setup this tunnel.
Possible values are none, rsvp, crldp, or other.
Cisco 12000/10700 v3.1.1 Router Manager User Guide
15-36
OL-4455-01