Removing A Vrf Policy From A Selected Interface; Vrf Association Window-Detailed Description; Vrf Tab - Cisco 12000 User Manual

Associating a VRF Policy with an Interface

Removing a VRF Policy from a Selected Interface

It is possible to remove the VRF policies from selected interfaces, only when the interfaces are in a
managed state and they are already associated with the VRF policy.
To associate a VRF policy with one or more selected interfaces, proceed as follows:
Step 1 Right click on the chassis object and choose Configuration> Interface> MPLS> VRF Association.
See
window. The VRF Association window appears, with the VRF tab displayed.
Choose a Chassis, and one or more Modules and Interfaces from the list displayed at the left of the
Step 2
window. For further information, see the
page
Note
Click the Remove button to remove the VRF policy from the interface. An Action Report window
Step 3
appears to inform you if the VRF policy has failed to be removed successfully.
VRF Association Window—Detailed Description
The VRF Association window (see

VRF Tab

The VRF tab displays four areas: Available VRF Policies, Actions, Associated VRF Policy Information,
and Apply Status.
Available VRF Policies
The Available VRF Policies area displays the following information:
VRF Policies—Displays a list of available VRF policies in the selected chassis.
Actions
The Actions area displays the following information:
Apply Button—Choose Apply to apply the selected VRF policies to the selected interfaces.
Remove Button—Choose Remove to remove the selected VRF policies from the selected interfaces.
Associated VRF Policy Information
The Associated VRF Policy Information area displays the following information:
Applied VRF Policy—Displays the VRF policy associated to the selected interface.
Cisco 12000/10700 v3.1.1 Router Manager User Guide
16-14
Table 16-1 on page 16-2 for information on which objects allow you to launch the VRF Association
16-14. You can multi select interfaces and modules but only one chassis.
To select a contiguous block of interfaces or modules, click on the first; then, hold down the
Shift key and click on the entry at the end of the group to be added. To add a non-contiguous
entry to the selection group, hold down the Ctrl (Control) key and click on the entry to be added.
A subsequent click anywhere on the window deselects all previous selections.
"VRF Association Window—Detailed Description" section on
Figure 16-10) displays the VRF Config tab.
Chapter 16 MPLS VRF Management
OL-4455-01