Configuring A Srp Interface; Srp Interface Configuration Window-Detailed Description; General; Ips - Cisco 12000 User Manual

Chapter 8 Interface Configuration

Configuring a SRP Interface

To configure a SRP Interface, proceed as follows:
Step 1 Launch the SRP Interface Configuration window. Refer to
which objects allow you to launch the SRP Interface Configuration window.
Step 2 Choose a Chassis, Module, and SRP Interface from the lists displayed at the left side of the window.
Step 3 Edit the parameters displayed in the SRP Interface Configuration window, as required. See
Interface Configuration Window—Detailed
Step 4 Click Save to save your configuration changes.
SRP Interface Configuration Window—Detailed Description
The SRP Interface Configuration window contains two areas: General and IPS

General

Topology Timer—Allows you to configure the time (in seconds) that determines the interval for sending
the topology discovery packets to the ring
Priority Threshold—Allows you to configure the incoming packet priority limit
Tx Traffic Rate – High—Allows you to configure the high rate limit of outgoing traffic, in megabits per
second
Tx Traffic Rate – Low—Allows you to configure the low rate limit of outgoing traffic, in megabits per
second
Note The Priority Threshold, Tx Traffic Rate – High, Tx Traffic Rate – Low parameters are applicable
only to OC-48 SRP Interfaces.

IPS

IPS Lock—Allows you to configure the boolean flag (true or false) to indicate node LockedOut of
protection state.
IPS Timer—Allows you to configure the frequency at which the IPS messages are to be displayed, in
seconds.
IPS Wait To Restore Timer—Allows you to configure the time interval in seconds, for an interface to
remain in the wrap state, after the cause of a wrap is removed.
OL-4455-01
Table 8-2 on page 8-2
Description" section for further details.
Cisco 12000/10700 v3.1.1 Router Manager User Guide
SRP Interface Configuration
for information on
"SRP
8-23