Creating And Configuring The Vrf Policy On A Device; Configuring And Creating A Vrf Policy On A Selected Chassis - Cisco 12000 User Manual

Creating and Configuring the VRF Policy on a Device

Choose Finish (when the Deployment Summary information is displayed) to complete deployment and
Step 11
close the Deployment Wizard - Summary window. The new VRF object (that is, VRF-1) is created and
displayed in the Map Viewer window beneath the Chassis object in the Software/VRF folder.
Figure 16-8 Example Showing the Newly Deployed VRF Object
The VRF object is now created (VRF-1 in the example in
now create and associate a VRF policy within the chassis. See the
Policy on a Device" section on page 16-8

Creating and Configuring the VRF Policy on a Device

This section describes the following areas:
•
•
•
•
•

Configuring and Creating a VRF Policy on a Selected Chassis

Note You can only create (upload) the policy to the device when the chassis object is in a managed state and
the VRF is not present (uploaded) in to the chassis already. It is not possible to modify the configuration
of VRF policy if it is already created (uploaded) in to the chassis. If you wish to modify a VRF policy
that is already on a chassis you must firstly remove the VRF policy from the chassis. To remove a VRF
policy from a chassis, see the
for further details.
Cisco 12000/10700 v3.1.1 Router Manager User Guide
16-8

Configuring and Creating a VRF Policy on a Selected Chassis

Removing a VRF Policy from a Selected Chassis
Adding a Routing Target to a Selected Chassis
Deleting a Routing Target from a Selected Chassis
VRF Configuration Window—Detailed Description
"Removing a VRF Policy from a Selected Chassis" section on page 16-10
Figure 16-8) and available in the EM. You can
"Creating and Configuring the VRF
for further details.
Chapter 16 MPLS VRF Management
OL-4455-01