Verifying Your Configuration; Configuring Charging Actions; Configuring Ip Readdressing - Cisco ASR 5000 Series Administration Manual

▀ Configuring the Enhanced Charging Service
group-of-ruledefs-application { charging | content-filtering | gx-alias | post-
processing }
end
Notes:
 A maximum of 128 ruledefs can be added to a group-of-ruledef.
 In 14.1 and earlier releases, a maximum of 64 group-of-ruledefs can be configured.
In 15.0 and later releases, a maximum of 128 group-of-ruledefs can be configured.
 The
group-of-ruledefs-application
specified, the system considers a group-of-ruledef as a charging group-of-ruledef.

Verifying your Configuration

To verify your configuration, in the Exec Mode, enter the following command:
show active-charging group-of-ruledefs name <ruledef_group_name>

Configuring Charging Actions

Charging actions are used with rulebases and must be created before a rulebase is configured.
To create a charging action, use the following configuration:
configure
active-charging service <ecs_service_name>
charging-action <charging_action_name>
content-id <content_id>
retransmissions-counted
billing-action { create-edrs { charging-edr <charging_edr_format_name> |
reporting-edr <reporting_edr_format_name> } + [ wait-until-flow-ends ] | egcdr | exclude-
from-udrs | radius | rf } +
end
Verifying your Configuration
To verify your configuration, in the Exec Mode, enter the following command:
show active-charging charging-action name <charging_action_name>

Configuring IP Readdressing

Readdressing of packets based on the destination IP address of the packets enables redirecting unknown gateway traffic
to known/trusted gateways. This is implemented by configuring the re-address server in the charging action.
▄ Cisco ASR 5x00 Enhanced Charging Services Administration Guide
88
command specifies the group-of-ruledef type. By default, if not
Enhanced Charging Service Configuration