Configuring A Srp Side - Cisco 12000 User Manual

Chapter 8 Interface Configuration
Click on the Alarms tab, if required.
Step 3
Figure 8-10 SRP Side Configuration window—Alarms tab

Configuring a SRP Side

To configure a SRP Side, proceed as follows:
Step 1 Launch the SRP Interface Side Configuration window. Refer to
on which objects allow you to launch the SRP Interface Side Configuration window.
Step 2 Choose a Chassis, Module, SRP Interface and SRP Side from the lists displayed at the left side of the
window.
Step 3 Edit the parameters displayed in the General and Alarm tabs, as required. See
Configuration Window—Detailed
Step 4 Click Save to save your configuration changes.
OL-4455-01
Description" section for further details.
Cisco 12000/10700 v3.1.1 Router Manager User Guide
SRP Interface Side Configuration
Table 8-2 on page 8-2 for information
"SRP Interface Side
8-25