Removing A Cos Queue Group From An Interface; Changing The Association Of A Cos Queue Group - Cisco 12000 User Manual

WRED Tx Configuration

Removing a CoS Queue Group from an Interface

To remove an applied CoS queue group from an interface, proceed as follows:
Step 1 In the Layer 3 QoS view, right-click on the desired CoS queue group, then choose Cisco 12000/10720
Manager>Configuration>QoS>WRED Tx Configuration. The WRED Tx Configuration window
appears (see
Step 2 Choose a Chassis, Module and Interface from the list boxes at the left of the window that contain the
CoS queue group that you wish to remove.
Choose Remove.
Step 3

Changing the Association of a CoS Queue Group

To change the association of a CoS queue group, proceed as follows:
Right click on a CosQ group object in the Layer3QoS view and choose Cisco 12000/10720
Step 1
Manager>Configuration>QoS>WRED Tx Configuration to launch the WRED Tx Configuration
window. See
Tx Configuration window (see
Choose the Chassis, Module and Interface from the list boxes at the left of the window that contain the
Step 2
interface(s) you want to apply the CoS queue group to. More than one Chassis, Module, and Interface
can be selected at a time.
Choose the CoS queue group you wish to apply.
Step 3
Note
Choose Apply. Previously applied CoS queue groups are removed and the new CoS queue group is
Step 4
applied.
Cisco 12000/10700 v3.1.1 Router Manager User Guide
11-30
Figure 11-13 on page
Table 11-1 on page 11-2
Figure 11-13 on page
Only one CosQ group can be applied.
11-29).
for information on which objects allow you to launch the WRED
11-29).
Chapter 11 Layer 3 QoS
OL-4455-01