Cisco 12000 User Manual page 480

Chapter 15 MPLS Management
Fault Management for MPLS LDP
ATM Parameters Tab
ATM parameters configuration is displayed in the ATM Parameters tab (see Figure 15-12) for LDP
entities that use ATM as their underlying technology. The ATM Parameters tab displays a single ATM
Parameters area.
Figure 15-12 MPLS LDP Entity Status Window—ATM Parameters Tab
ATM Parameters
The table displays the following information:
Local LDP Id—Displays the LDP identifier.
Index—This index is used as a secondary index to uniquely identify this row.
Associated Interface Name—This value represents the Interface Name where the ATM Labels would be
created. The Value 0 means the Interface is not known.
Merge Cap—Displays the Merge Capability of this entity. Possible values are notSupported, or vcMerge.
LR Components—Number of Label Range Components in the Initialization message.
VC Directionality—This value represents whether to use a given VCI, within a given VPI, as a label in
unidirectional or bi-directional.
LSR Connectivity—The peer LSR may be connected indirectly by means of an ATM VP so that the VPI
values may be different on either endpoint so the label must be encoded entirely within the VCI field.
DefaultControl VPI—The default VPI value for the non-MPLS connection. The default value of this is
0 (zero) but other values may be configured. This object allows a different value to be configured.
Cisco 12000/10700 v3.1.1 Router Manager User Guide
15-24
OL-4455-01