Oam Ping Tab - Cisco 12000 User Manual

ATM PVC Configuration
Subscriber
The Subscriber area contains one field:
Subscriber ID—Type in your subscriber ID.
OAM Parameters
The OAM Parameters area contains the following fields:
Manage—If this value is set to yes, then the value in frequency will be considered.
Frequency—Specify the frequency (in seconds) that end-to-end OAM loopback cells should be
transmitted when a change in up or down state is being verified.
Retry Down Count—Specify the number of consecutive end-to-end OAM loopback cell responses that
are not received in order to tear down a PVC.
Retry Up Count—Specify the number of consecutive end-to-end OAM loopback cell responses that must
be received in order to change a PVC connection state to up.
Retry Frequency—If a PVC is up and a loopback cell response is not received after the specified
frequency attribute, then loopback cells are sent at the retry frequency to verify whether or not the PVC
is down.
Autodetect—If the value is set to yes, initiates auto-detection of the peer OAM command cells.
Optimum—If the value is set to yes, configures an optimum mode so that when the traffic monitoring
timer expires, the PVC sends an OAM command cell at the locally configured frequency instead of going
into Retry mode immediately. If there is no response, the PVC goes into Retry mode.
Actions
The Action area contains three buttons:
Connect—Allows you to connect the selected PVC, creating the connection on the device, making it real
and active.
Disconnect—Allows you to disconnect the selected PVC, disconnecting the connection on the device,
making it inactive.
Decommission—Allows you to decommission the selected PVC.

OAM Ping Tab

The OAM Ping tab displays an area, OAM Ping Parameters.
OAM Ping Parameters
Timeout in seconds—Timeout interval. The default value is set to two seconds.
Repeat Count—Number of ping packets that are sent to the destination address. The default value is set
to five.
Loopback—The type of the ATM OAM Ping options. The available values are: end-loopback and
seg-loopback.
Last Ping Result—Status after the last ping operation for the selected PVC.
Cisco 12000/10700 v3.1.1 Router Manager User Guide
12-36
Chapter 12 Managing ATM Connections
OL-4455-01