Creating Atm Connections; Uploading Existing Atm Connections And Qos Profiles - Cisco 12000 User Manual

Chapter 12 Managing ATM Connections
Table 12-5 CemfIsMasterAfterFirstSync Policy (continued)
VCL in Cisco EMF
Not Present
Not Present

Creating ATM Connections

To create a PVC or SVC, proceed as follows:
1.
2.

Uploading Existing ATM Connections and QoS Profiles

This section describes how to upload existing ATM connections and profiles (previously configured on
a Cisco device) into the Cisco 12000/10720 Router Manager application. Uploading saves time and
effort re-configuring ATM connections and profiles that already exist on the device.
When you upload PVCs, any corresponding ATM QoS profiles are also uploaded. PVCs are discovered
and placed into the normal state, so that management of these connections begins automatically. Once
these connections and/or profiles are uploaded, you can view and adjust them within Cisco 12000/10720
Router Manager. Existing ATM connections and QoS profiles are uploaded from the ATM Connection
Upload window.
The processes of uploading ATM connections and synchronizing the connections function in a similar
Note
manner to upload the existing ATM connections and QoS profiles. So, any policy set for synchronization
(i.e. Normal, Device_is_Master, or CEMF_is_Master_after_first_sync) is applicable to Upload as well.
Refer
Synchronization.
OL-4455-01
VCL State
N/A
N/A
Upload any existing ATM connections and QoS (Quality of Service) profiles, if available (for
details, see "Uploading Existing ATM Connections and QoS Profiles" section on page
Create an ATM QoS profile, when required (see
page 12-12 for further details):
Deploy (create) the PVC or SVC in the CEMF, using the Deployment Wizard (for details, see
a.
"Deploying a PVC Object" section on page 12-18
page 12-22). This process creates the PVC or SVC in Cisco EMF only; it does not create the
connection on the device.
b. Apply the QoS profile to the PVC or SVC (for details, see
ATM Connection" section on page
c. Configure the fields for the PVC or SVC, including layer 2 information (for details, see
PVC Configuration" section on page 12-30
You can then create the connection on the device by commissioning the PVC or SVC for
management.
ATM Connection Synchronization
VCL on Device
Present
Not Present
"Managing ATM QoS Profiles" section on
or "Deploying an SVC Object" section on
"Applying an ATM QoS Profile to an
12-28).
or the "SVC Configuration" section on page
section for details on policy setting for ATM Connection
Cisco 12000/10700 v3.1.1 Router Manager User Guide
Creating ATM Connections
Behavior
Remove it from device
N/A
12-7) or
"ATM
12-37)
12-7