Configuration; Verifying Snmp, Log, And Trap Settings - Cisco 12000 User Manual

Chapter 21 Troubleshooting and FAQs
Table 21-4 Dialogs launched from Interface objects
Dialog uses IOS CLI
(Need to set the Management
Passwords on the EM)
ATM Interface Configuration
ATM Interface Faults
ATM Interface Status
IP Interface Configuration
Ethernet Interface Configuration
POS Interface Configuration
POS APS Configuration
CAR Policy Apply
CAR Policy Status
WRED-Tx Configuration
ATM PVC Connection Deployment
ATM SVC Connection Deployment
ATM PVC Configuration
ATM SVC Configuration
Deployment of Vlan-Domains, VLANs
and sub-interfaces
VLAN Performance
VRF Association

Configuration

Verifying SNMP, Log, and Trap Settings

Q.
A.
OL-4455-01
Dialog uses SNMP
Generic Interface Configuration
Generic Interface Performance
Generic Interface Status
SONET Interface Status
SONET Interface Performance
DS3 Interface Status
DS3 Interface performance
Ethernet Interface Performance
MPLS Interface Performance
MPLS Interface Information
ATM PVC Status
SRP Interface Topology Map
SRP Side Performance
SRP Interface Performance
VLAN Synchronization
Three GSRs are configured and commissioned. I believe the Cisco 12000/10720 Router Manager is
talking with the GSRs since the GUI shows the number of alarms that each GSR has.
How do I verify that SNMP, TRAP, and LOGGING are configured correctly? Are there any specific
CLI commands I can use to verify?
In Cisco EMF, when a condition (fault) occurs on a managed object in the network, the system is
notified immediately. This notification is shown as an event and can be viewed with the Event
Browser. The Event Browser is opened from the Launchpad or from a selected object.
For details on Event Browser, refer to the Cisco EMF Release 3.2 Service Pack 4 User Guide,
http://www.cisco.com/en/US/products/sw/netmgtsw/ps829/products_user_guide_chapter09186a00
800ffd09.html
Dialog uses IOS CLI and SNMP
(Need to set the Management
Passwords on the EM)
SRP Interface Configuration
SRP Interface Status
SRP Side Interface Configuration
IPS Status
Cisco 12000/10700 v3.1.1 Router Manager User Guide
Configuration
21-3