Cisco 12000 User Manual page 481

Chapter 15 MPLS Management
Fault Management for MPLS LDP
DefaultControl VCI—The default VCI value for a non-MPLS connection. The default value of this is 32
but other values may be configured. This object allows a different value to be configured.
Unlab Traffic VPI—VPI value of the VCC supporting unlabeled traffic. This non-MPLS connection is
used to carry unlabeled (IP) packets. The default value is the same as the default value of the
DefaultControlVpi, however another value may be configured.
Unlab Traffic VCI—VCI value of the VCC supporting unlabelled traffic. This non-MPLS connection is
used to carry unlabelled (IP) packets. The default value is the same as the default value of the
DefaultControlVci, however another value may be configured.
Storage Type—The storage type for this entry.
ATM Label Range Tab
Configured ATM label range parameters are displayed in the ATM Label Range tab (see Figure 15-13)
for LDP entities that use ATM as their underlying technology.
The ATM Label Range tab displays a single ATM Label Range area.
Figure 15-13 MPLS LDP Entity Status Window—ATM Label Range Tab
ATM Label Range
The table displays the following information:
Local LDP Id—Displays the LDP identifier.
Index—This index is used as a secondary index to uniquely identify this row.
Label Range Min VPI—The minimum VPI number configured for this range.
Cisco 12000/10700 v3.1.1 Router Manager User Guide
15-25
OL-4455-01