Table 3: Dgps Status Messages - NorthStar 961 Reference Manual

Chapter 5 - Understanding Position Coordinates
Message
IN USE/ OK
OLD CORRECTIONS
NOT INSTALLED
BEACON UNHEALTHY
UNHEALTHY SATELLITES
BAD UDRE/IODE
ACQUIRING SATELLITES
DGPS NOT IN USE, BUT AVAILABLE
USER TURNED OFF
SEARCHING
POOR DOPS
TOO FEW SATS
Page 5-6
Status messages
A message about DGPS operations is displayed at the lower
half of the GPS SATELLITE STATUS screen. These messages
are described in "Table 3: DGPS status messages" below.

Table 3: DGPS status messages

Meaning
DGPS corrections are being received and used.
No DGPS corrections have been received within the
time limit. The system has returned to non-differential
operation.
A differential receiver isn't installed.
The differential (beacon) transmitter reports technical
problems.
Data received from the satellites is unreliable.
Data received from the satellites is unreliable.
Either the GPS receiver can't operate until it has
received ephemeris data from the satellites, or else
the receiver isn't tracking enough satellites yet for a
fix.
DGPS was turned off at the
screen.
The 961/962 beacon receiver is present, but the
DGPS system was turned off (at the
SETUP
The system is waiting for the 961/962 beacon receiver
to report fully synched differential data.
The monitor station that measures differential data
currently has poor satellite geometry.
There are too few satellites available.
screen).
961/962 Operations and Reference Manual, Rev. A
RECEIVER SETUP
RECEIVER