NorthStar 961 Reference Manual page 229

961/962 Operations and Reference Manual, Rev. A
Adding an existing waypoint to the end of the trip
1. Press the CURSOR PAD to select a waypoint on the
CHART screen, then press the CURSOR menu key.
The SELECTED WAYPOINT dialog box appears.
2. Press the ADD TO END OF TRIP key.
The CHART screen appears, and the existing point is
added to the end of your trip (press the TRIP key to see
this point on the TRIP screen). If you were already past
the end of the trip, you'll immediately begin navigating
along the leg to the new waypoint.
Going directly to any location on the chart
Using the cursor on the CHART screen, you can go to an
entirely new waypoint:
1. Press the CURSOR PAD to move the cursor to the desired
location on the CHART screen (to establish a precise
position, press the IN or OUT keys to zoom the chart view
in or out).
2. Press the CURSOR menu key.
The SELECTED CURSOR POSITION dialog box
appears. If desired, use the KEYPAD to change the
displayed coordinates before moving to the next step. You
can also view the coordinates as either lat/lon or TDs by
pressing the TDS,LAT/LON key.
Chapter 10 - Waypoint and Route Navigation
Page 10-15