Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
Figure 305
Enabled MPT-HL/MPT-HLC transceiver
5.
To enable an MPT-HL or MPT-HLC transceiver on Core
1. Select the slot where the MSS/CORE card is equipped to support the MPT-HL/
2. Click the Settings Tab in the resource detail area. See
Caution: When parallel radio paths exist between two MSS shelves, port
segregation should be provisioned between the parallel radio paths at both ends
to prevent a loss of traffic.
Verify port segregation provisioning. Port segregation should be provisioned
between parallel MPT-HL/MPT-HLC radio paths at both ends when they exist on
the NE. Port segregation should be provisioned between the P8ETH or EASv2
MPT-HL/MPT-HLC port and other Ethernet and/or radio ports where
connectivity is not desirable. See
detailed steps to view/provision port segregation.
MPT-HLC transceiver in the resource tree area. The selected name will highlight
in blue. This selection also highlights the Core card in blue on the graphical
representation of the MSS shelf in the resource list area.
Provision port segregation/connectivity
Figure
Enable equipment
for
306.
489
Advertisement
Table of Contents
