Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
Configure radio parameters
Note: The Channel #1 Rx Freq (KHz) field displays the Rx RF Frequency and is the result
of the following calculation: RX Frequency = TX Frequency - Shifter Frequency
Note: In a Protected MPT-HLS configuration, the Main and Protect MPT-HLS cards use the
same CT screen. The parameters on the Spare (Channel #0) part of the screen are the
same as the Main (Channel #1) part of the screen. Most Channel #0 fields will be
automatically populated to match Channel #1, except the transmit power. The transmit
power must be configured independently.
31. Select an action.
32. Provision the MPT-HLS radio for adaptive modulation
Note: The Reference Modulation should be set to a value lower than or equal to 256 QAM.
836
ii. Click on the Data Help button under the Mode field. The Data Help window
opens.
iii. In the Data Help window, double-click on the table row for the desired
channel spacing, modulation scheme, and option.
iv. Click on the Data Help button in the Shifter panel. The Data Help window
opens.
v. In the Data Help window, double-click on the table row for the desired shifter
value.
vi. When the MPT-HLS is connected to the MSS shelf, the Channel #1
TxFreq(KHz) field is automatically populated. If the MPT-HLS is not
connected, enter the TX RF Frequency within the allowed range.
vii. If the MPT-HLS is not connected, enter the Rx RF Frequency within the
allowed range.
viii. Enter the MPT-HLS radio channel User Label, if applicable.
ix. Click Apply.
a. To
Provision the MPT-HLS radio for fixed
b. To
Provision the MPT-HLS manual transmit power level
step 38.
c. To
Provision the MPT-HLS Automatic Transmit Power Control
to step 43.
WebEML User Manual
modulation, go to step 29.
(RTPC), go to
(ATPC), go
Advertisement
Table of Contents
