Nokia 9500 MPR User Manual page 875

Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
69. Provision the MPT ODU Point to Point Protocol settings
70. Provision the PKT throughput booster setting
71. Administer the MPT ODU Alarm Profile settings
72. Provision the MPT ODU radio channel encryption
Note: Before provisioning radio channel encryption, verify the radio channel is running error
free and operating correctly.
i. From the PPP RF panel, select the Enabled check box; see
ii. Select Routing IP Protocol: (OSPF or None).
iii. If OSPF is selected, then select OSPF Area: (0 to 4).
NOTE: OSPF Area must be provisioned prior to provisioning PPP RF
channel.
iv. Click Apply.
i. From the Pkt Throughput Booster panel, select the Enabled check box; see
Figure 656.
ii. Click Apply.
i. In the Alarm Profile panel, click on the icon; see
Severity Profile window opens.
ii. Choose an alarm severity profile. Select the Show details button for more
information if needed.
iii. Click Apply.
If the radio is remotely managed, the encryption should be configured on the
remote radio before the local one. The configuration change will cause the
remote radio to become temporarily unreachable until the local radio is also
configured.
Encryption mismatch is not part of the switching criteria for L1 LAG or ERPS. To
avoid traffic interruption if the radio is part of an L1 LAG or ERPS topology, mute
the transmitter before configuring encryption.
Open the appropriate radio main view depending on your radio configuration
and select the Additional Settings tab; see
If the radio is part of an L1 LAG or ERPS topology, mute the transmitter; see
administer the Tx Mute
i. Click on the Edit passphrase button.The Edit passphrase window opens.
Figure
settings.
Configure radio parameters
Figure 656.
Figure 656. The Alarm
656.
To
875