Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
51 Enable equipment
51.1 Purpose
This chapter provides procedures to enable cards into the system. See the
9500 MPR Product Information Manual for information about supported equipment.
See the Release Notice for information about supported radios by interface type.
51.2 Prerequisites
Communication with the MSS shelf using the craft terminal must be established.
51.3 Procedures
This section provides the following procedures:
Note: The Core graphics in this chapter show the Core-E card. The procedure is
similar for a CorEvo card.
•
To enable a spare Core card
•
To enable a P8ETH card
•
To enable an EASv2 card
•
To enable an MPT-HL or MPT-HLC transceiver card on P8ETH or EASv2 card
•
To enable an MPT-HL or MPT-HLC transceiver on Core
•
To enable an E1/DS1 P32E1DS1 card
•
To enable a DS3 P2E3DS3 card
•
To enable an SDH card
•
To enable an MPT access card
•
To enable MPT ODU on MPTACC card
•
To enable an MPT ODU on Core
•
To enable an MPT ODU on P8ETH or EASv2 card
Enable equipment
477