Nokia 9500 MPR User Manual page 323

Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
Note: To disable a LAG port, all cross-connections, VLANs, and Port segregation,
synchronization reference provisioning must be removed from the LAG port.
If the L2 Ethernet LAG port is configured as UNI (VLAN-Based) in Provider Bridge mode, to
disable a LAG port, Ingress C-VLAN / S-VLAN Mappings must be removed.
3. Configure Provider Bridge port type of an L2 Ethernet LAG port
Note: The NE must be in Provider Bridge mode.
4. Verify that the LAG port is enabled. To enable it, go to step 1.
i. From the Configured LAGs pane, select LAG to disable.
ii. From the LAG Information pane, select the Enabled check box
(unchecked).
iii. Click Apply.
Using the LAG Configuration Tool Settings tab, configure the port type using the
following procedure: See
i. From the Configured LAGs pane, select the L2 Ethernet LAG.
ii. Select the Provider Bridge tab.
iii. Choose the port type: NNI, UNI (port-based), or UNI (VLAN-based).
Administer L1/L2 radio and L2 Ethernet LAG
Figure 177.
ports
323