Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
Administer synchronization
11. From the E1/DS1 Port drop-down menu, select the E1/DS1 Port.
12. Select Secondary Source radio button: Free Run Local Oscillator, E1/DS1
13. Go to step 20.
14. From the Eth Port drop-down menu, select the Eth Port.
15. Select Secondary Source radio button: Free Run Local Oscillator, E1/DS1
16. Go to step 20.
17. From the STM-1/OC-3 Port drop-down menu, select the STM-1OC-3.
18. Select Secondary Source radio button: Free Run Local Oscillator, E1/DS1
19. Go to step 20.
20. Which secondary source was selected?
21. In the Sync Ports partition, from the Sync In port drop-down menu, select the
338
Port, Sync-In Port, Eth Port, STM-1/OC-3 port, or None.
Port, Sync-In Port, Eth Port, STM-1/OC-3 port, or None.
Port, Sync-In Port, Eth Port, STM-1/OC-3 port, L1 Radio LAG port, or None.
a. If Sync-In Port, go to step 21.
b. If E1/DS1 Port, go to step 23.
c. If Eth Port, go to step 25.
d. If STM-1/OC-3 Port, go to step 27.
e. If Free Run Local Oscillator, go to step 29.
f. If None, go to step 29.
Sync In Port frequency: 1.024 MHz, 2.048 MHz, 5 MHz, or 10 MHz.
Note: If a Sync-In/Out SFP is in use, the Sync Ports area is labeled Sync In/Out
SFPs. The Sync In Port appears as NOT USED. The SFP is displayed as Sync
In Port #5, #6, #7, #8, depending on where the SFP is placed; see
WebEML User Manual
Figure
186.
Advertisement
Table of Contents
