Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
26 Use the Ethernet Features Shell
26.1 Purpose
This chapter provides procedures for using the Ethernet Features Shell from the
JUSM interface.
See the 9500 MPR Product Information Manual for more information.
26.2 Introduction
Ethernet Connectivity Fault Management (ECFM) (IEEE802.1ag) is performed using
the Ethernet Features Shell.
See the 9500 MPR Product Information Manual for more information about the
following types of commands that can be run from the Ethernet Features Shell:
26.3 Procedure
To open the tool
1. From the main menu bar, select Configuration > Ethernet Features Shell.
2. A warning window opens, advising that starting a CLI session will shut down the
3. The Protocol Selection window opens. Select the protocol you need to use to
• Ethernet Connectivity Fault Management
• Ethernet CFM
• Protocols
• TACACS+
CT. Click on the Yes button to continue.
transfer data. If you need to use SFTP, enter the username and password to
connect to the NE.
Use the Ethernet Features Shell
209