Table 6 Configurations In Monodirectional Links - Nokia 9500 MPR User Manual

Release 7.0.0 3DB 19286 ACAA Issue 01
Configure radio parameters
Provision the radio protection scheme before provisioning MPT-HLx/MPT ODU radio
channel parameters. If MPT-HLx/MPT ODU radio parameters are provisioned before
the protection scheme, unexpected radio alarms may be reported on the radio
channel. To clear these unexpected radio alarms, a system restart is required.
Note: Most procedures are shown using the MSS-8 screen. However, the operation is
similar for all MSS shelves.
Note: All supported channel plans do not support all possible radio profile combinations. For
a table of supported profiles per radio channel plan, see the 9500 MPR Product Information
Manual Engineering Specifications section.
59.2.1 Monodirectional links
For the management of monodirectional radio links, different configurations are
needed on each side of the link.
Table 6 Configurations in monodirectional links
Parameter
ATPC
ACM
L1 LAG
Ring
Radio PM
Link identifier
PPP
No Rx Radio Alarms alarm
profile
786
Table
Tx only node
Should not be enabled; cannot
work
Should not be enabled; cannot
work
Should not be enabled; cannot
work
Should not be enabled; cannot
work
Should not be enabled; it works
on the Rx side
Should not be enabled; it works
on the Rx side
Must be disabled (otherwise a
PPP Failure alarm will be raised)
Must be configured in the radio
panel (otherwise all the Rx Radio
alarms will be raised)
WebEML User Manual
6describes the configuration requirements.
Rx only node
Should not be enabled; cannot
work
Should not be enabled; cannot
work
Should not be enabled; cannot
work
Should not be enabled; cannot
work
Can be enabled
Can be enabled
Must be disabled (otherwise a
PPP Failure alarm will be raised)
—