Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
Configure radio parameters
60. Provision MPT-HLC radio PKT throughput booster:
61. Administer the MPT-HLS Alarm Profile settings
62. In the Alarm Profile panel, click on the icon. The Alarm Severity Profile window
63. Choose an alarm severity profile. Select the Show details button for more
64. Click Apply.
65. Provision the MPT-HLS radio channel encryption
Note: Before provisioning radio channel encryption, verify the radio channel is running error
free and operating correctly.
66. If the radio is part of an L1 LAG or ERPS topology, mute the transmitter; see
846
Open the appropriate radio main view and select the Additional Settings tab; see
Figure
633.
See
Figure 633
for the following steps:
i. From the Pkt Throughput Booster panel, select the Enabled check box.
ii. Click Apply.
Open the appropriate radio main view and click on the Additional Settings tab;
see
Figure
633.
opens.
information if needed.
If the radio is remotely managed, the encryption should be configured on the
remote radio before the local one. The configuration change will cause the
remote radio to become temporarily unreachable until the local radio is also
configured.
Encryption mismatch is not part of the switching criteria for L1 LAG or ERPS. To
avoid traffic or supervision interruption if the radio is part of an L1 LAG or ERPS
topology, execute a mute procedure of the radio link before configuring
encryption. Proceed radio link by radio link.
Open the appropriate radio main view depending on your radio configuration
and select the Additional Settings tab; see
administer the Tx Mute
Figure
settings.
WebEML User Manual
633.
To
Advertisement
Table of Contents
