Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
41.3 Procedures
This section provides the following procedures:
To launch the LAG Configuration tool
1. Launch Link Aggregation L1/L2 Configuration (LAG Configuration) tool from the
Figure 166
LAG Configuration icon
•
To launch the LAG Configuration tool
•
To provision an L1 Radio LAG port
•
To provision an L2 radio LAG port (not available with a CorEvo card)
•
To create an L1/L2 Radio or L2 Ethernet LAG port
•
To add Ethernet or radio ports to LAG port
•
To remove Ethernet or radio ports from a LAG port
•
To enable a LAG port
•
To destroy an L2 Ethernet or L1/L2 Radio LAG port
•
To administer PPP RF configuration
•
To provision hashing level for L2 Ethernet/radio LAG port
•
To enable SSM support for L1 radio LAG port
•
To enable PTB for L1 radio LAG port
•
To provision Wait-To-Restore (WTR) value
craft terminal. Click the LAG Configuration Icon, see
main menu bar, select Configuration > LAG Configuration.
LAG Configuration tool opens. See
Administer L1/L2 radio and L2 Ethernet LAG
Figure
Figure
167.
ports
166, or from the
307
Advertisement
Table of Contents
