Provision Equipment Port; Purpose; General - Nokia 9500 MPR User Manual

Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual

49 Provision equipment port

49.1 Purpose

This chapter provides procedures to provision equipment ports.

49.2 General

While provisioning PDH circuits (E1, DS1 or DS3) the service profile must be
provisioned either TDM2TDM or TDM2ETH.
Provision the PDH circuit TDM2TDM when both termination points of the PDH circuit
are terminated on 9500 MPR equipment.
Provision the PDH circuit TDM2ETH when one of the termination points of the PDH
circuit is terminated on non-9500 MPR equipment, and the other equipment is MEF-8
compliant.
TDM clock source for E1/DS1 and DS3 ports provisioned TDM2TDM support
differential clock recovery.
TDM clock source for E1/DS1 and DS3 ports provisioned TDM2ETH support either
adaptive or differential clock recovery. All ports on a E1/DS1 and DS3 card must be
provisioned to the same type of clock recovery, either adaptive or differential.
While provisioning SDH circuits (SDHACC) the service profile must be provisioned
SDH2SDH.
10 G/bit SFPs can be provisioned in CorEvo-10G ports 5 and 6 if a license is present.
Note: All procedures are shown using the MSS-8 screen, however, the operation is similar
for all MSS shelves.
Provision equipment port
429